Line pulldown menu
Commands from the Line pulldown menu are used to manipulate laser points based on line information or to create and modify lines.
TO |
USE COMMAND |
---|---|
Assign line number to laser points from trajectory information |
|
Assign line number to laser points from scan pattern |
|
Start a new line from a selected laser point |
|
Modify the numbering of lines |
|
Draw approximate flight path |
|
Apply a boresight angle correction |
Adjust laser angles Not Lite |
Remove points from long range measurements |
Cut long range Not Lite |
Remove points with low reliability values |
Cut low reliability Not Lite |
Remove points from overlapping lines |
Cut overlap Not Lite |
Fit a point cloud to control measurements or to a reference point cloud |
|
Shift a point cloud interactively |
|
Rotate a point cloud interactively |
The Line pulldown menu is not available if laser data is loaded into TerraScan using the Load Ground Points tool or if the point cloud type is set to Stationary lidar when points are loaded with the Read points command. In this case it is replaced by the Measurement pulldown menu which offers special commands for laser data from static terrestrial scanners.